The term ?dissipation loss? are available in the info sheet for a pressure sensor or pressure transmitter. One needs this specification in order to be able to protect the pressure sensor from overheating.
In case a pressure sensor is operated in a hot environment, it might be necessary to limit its electrical power. If one neglects this aspect, one possibly risks an overheating sufficient reason for this, in the worst case, a total failure of the instrument. So how can the correct electrical connection be managed?
Determination of the correct electrical connection on the basis of the dissipation loss
First, the maximum permissible electrical power for the pressure sensor should be known. This is given in the data sheet because the dissipation loss. Please be Bargain that the dissipation loss can be dependent upon the maximum expected operating temperature of the instrument and should be calculated where necessary.
If the allowable dissipation loss has been determined correctly, then your actual maximum electrical energy for the pressure sensor that occurs could be determined. The determination can be executed expediently in two steps:
1. Determination of the voltage at the pressure transmitter using the following formula:
UPressure transmitter = UVoltage source ? RLoad � Imax. Current supply
2. Calculation of the maximum electrical energy for the pressure transmitter through the following equation:
PPressure transmitter = UPressure transmitter � Imax. Fail-proof for the pressure transmitter (PPressure transmitter), that is now known, should be smaller than the permissible dissipation loss. If this is actually the case, both the power supply (UVoltage source) and the strain (RLoad) were properly calculated and the electrical power of the pressure sensor will be within the permissible range under all operating conditions. Consequently, the pressure transmitter will not heat too strongly and will withstand the mandatory operating temperatures.
Note
Should you need any advice, your contact will gladly help you.

Leave a Reply